 Unboxing the Blu E Cigs
The first step is to open up the box. Inside your Blu E Cigs Starter Kit you will find:
-
One Blu E Cigs pack, which holds five cartridges and charges your batteries on the go!
-
Two Blu E Cigs batteries
-
One wall charger
-
One USB charger
-
One five-pack of cartridges in the strength and flavor of your choice
Setup The BLU E CIGS
For optimal performance, it is recommended that you fully charge the batteries and Blu E Cigs pack before using Blu E Cigs.
You will notice that one of the batteries and an empty cartridge are pre-assembled. Simply replace the empty cartridge with a full one by screwing a new one onto the battery.
There is no on or off switch. As you press Blu E Cigs to your lips and inhale, the Blu E Cigs LED light at the tip glows like a real cigarette to let you know it's working.
 Blu E Cigs Charging Pack
Both the pack and the batteries can be charged using a standard wall outlet, or computer with USB port.
To charge the pack using a wall outlet, simply plug the wall charger into the outlet and connect the opposite end to the bottom of the pack. When the Blu E Cigs light at the end of the cord is on, the pack is charging. When the light turns off, your pack is fully charged.
To charge the pack using the enclosed USB charger, unplug the USB cord from the wall charger and connect one end of the cable to the pack and the other to the USB port. When the Blu E Cigs light at the end of the cord is on, the pack is charging. When the light turns off, your pack is fully charged.
More Info
 Blu E Cigs Pack as Battery Charger
Second from the right, inside each pack, is a battery receptor.
Screw the battery into the receptor until it is secure. The Blu E Cigs LED light on your battery will flash and the Blu E Cigs light on the side of the pack will light up. When the light is on it means the battery is charging. When the light turns off, the battery is completely charged.
Simply unscrew the battery from the receptor and leave it in the same slot in the pack. If the battery is left screwed into the receptor after charging it will drain the charge from the battery.
 Blu E Cigs Battery Replacement
When the battery is depleted, the Blu E Cigs LED at the end of the battery will blink 30 times intermittently to signal it is ready to be recharged.
To replace the empty battery, secure the cartridge in one hand and unscrew the battery from the cartridge. Grab the fresh battery from your Blu E Cigs pack and reattach it to the cartridge. When you're finished, recharge the empty battery by screwing it back into the receptor.
Remember to unscrew a newly charged battery from the receptor when the light on the side of your pack goes out. Note: During use, the LED light will flash 5 times to warn you that you are over using your Blu E Cigs and you should take a break. This does not affect performance and does not mean you should recharge.
More Info
 Blu E Cigs Cartridge Replacement
On average, each individual cartridge supplies enough nicotine and premium flavoring to accommodate approximately 250 puffs. When the cartridge no longer produces vapor, you'll know it's time for a replacement.
To replace the blu-e-cigs cartridge, hold the battery with one hand and unscrew the cartridge from the battery.
Take a new cartridge and screw it onto the battery and you are ready to resume.
Note: If you are leaving your Blu E Cigs for a period of time and not using, unscrew the cartridge from the battery slightly so it is not activated while not in use. it’s not on – leave the plastic cap and leaf seal on your cartridges until you are ready to use them.
More Info
| 
How It Works
